New MachinesUsed MachinesSpecialsContact UsSite Map

PDF Brochure




HIGH SPEED MARK OR FULLY AUTOMATIC DEFECT SCANNING SAW

EXPRESSLY DESIGNED FOR DEFECTING SOLID AND ENGINEERED WOOD BOARDS, STRIPS, AND FLOORING BLANKS

FEATURES NEW HASKAN CRAYON READER AND OPTIONAL FULL AUTOMATIC DEFECT SCANNING SYSTEM

HASKO "TUFF-ENOUGH" FOR FLOORING PLANTS---NOT JUST ANOTHER GENERIC "CUT-ALL"

DESIGNED & MANUFACTURED IN OUR TENNESSEE PLANT, AND IS BACKED BY HASKO'S DEDICATED SERVICE, ENGINEERING, AND TECHNICAL DEPARTMENTS!






Product Advantages:
  • Small stand-alone footprint permits easy integration into existing defecting lines

  • Designed and built by Hasko specifically for the requirements of the Wood Flooring Industry

  • Workable average high production rate of approximately 250-300 lineal feet per minute on 30" average cut length basis

  • Potentially replaces two or more typically hazardous conventional chop defect saws

  • New Haskan scanning software delivers accurate defecting "On The Mark"

  • Programmable electronic AC Servo Motors provide range of speeds for varying applications

  • Full enclosure with safety interlocks minimizes operator's intrusion into saw cutting area

  • Optionally available as a fully automatic defect optimizing system



    CAPACITIES
    Maximum Size:
    Width: 8" x 1" thick, or 7" x 1.5" thick
    Thickness: Up to 2"
    Length: Unlimited

    Minimum Size:
    Width: 1-1/4"
    Thickness: 1/4"
    Length: 9"

    Production Rates:
    Through-Put: 250-300 FPM on 30" average cut lengths

    Saw Blade:
    Size: 18", 30 mm bore
    Speed: 3165 RPM

    MOTORS & ELECTRICALS
    Saw And Stroke Motors:
    Saw Arbor: 15 H.P., 3450 RPM
    Motor Type: Standard arbor motor
    Stroke Motor: 16.6 H.P. AC Servo
    Actuation: Mechanical, Less than 1/16 second cut cycle

    Feed System Motors:
    Feed Motor: 16.6 H.P. AC Servo
    Speed: Variable, 1300 FPM maximum
    Positioning: 0 to 4": Less than 1/16 sec.
    Positioning: 0 to 64": Less than 1/4 sec.

    Electrical System:
    Panel: NEMA standards, pre-mounted
    Controls: Solid state PLC, and servo drives
    Voltage: Standard is 440/60/3

    COMPONENT DETAILS
    Feed Mechanism:
    Bottom Drive Rolls: Seven 4" dia. steel hard chromed & corrugated
    Top Idle Rolls: Seven 4" dia. smooth steel rolls w/air tension
    Roll Drive: Via toothed belts

    Scanning Method:
    Standard: Fluorescent crayon
    Opt: Haskan defect scanning

    Control Software:
    Feed Rate: Programmable PLC
    Scanner: Haskan software

    OTHER DETAILS
    Envelope:
    Std. Machine: 55" long x 36" wide x 78" high
    Weight: Appx. 3,000 pounds
    Bedline Height: 35-1/2"
    Other: Per customer application

    Air & Dust Requirements:
    Dust Chute Size: 5", 625 CFM
    Air Req'd: 2 CFM @80 psi.

    Optional Equipment:
    Infeed & Outfeed Conveyors
    Full Automatic Defect Scanning
    Voltage other than standard
    Cut capacity other than standard